Magnum MIG 160 Mini, Руководство пользователя

Страница: 10 / 18

10
Insulated wire of yellow-green is grounded and should always be connected to the outlet marked
earth, regardless of whether there is power supply 230 [V] and 400 [V].
Symbol earth (PE).
7.2 Inserting the conductors MIG-MAG welding.
ATTENTION! Before all work carried out on the unit, unplug the power cord.
1. Make sure that the device is not connected to the mains. 1. Make sure that the device is not connected to the mains.
2. Check that the ground wire is terminated by a clamp or screw. 2. Check that the ground wire is terminated by a clamp or screw.
3. Plug the cable connected to the mass located on the front panel slot "4" or "7" push and twist. A 3. Plug the cable connected to the mass located on the front panel slot "4" or "7" push and twist. A
loose connection causes premature firing pin plug and socket current. The ground wire in the
MIG-MAG typically connect to the "- '', when using self shielding wire to the" + ".
In the second, empty nest insert connector connected to the built-in cable. It is necessary to
close the circuit. Without the plug plugged into one of the slots "4" or "7" unit will not weld!
4. Before putting the welding wire make sure the appropriate armor is established next to the 4. Before putting the welding wire make sure the appropriate armor is established next to the
appropriate diameter and type of electrode wire. To facilitate the manufacture of armor guiding them
label the appropriate colors. For a wire diameter
0.6 to 0.8 mm, a blue color, the wire having a diameter of 1.0 ÷ 1.2 mm, color red, and for a wire electrode
with a diameter of 1.6 mm color yellow. For welding stainless steel and aluminum, Teflon armor use. For the
welding of low carbon steel, low alloy steel, copper, bronze, etc., Are used with spiral metal armor. It should
be remembered accessories from the welding torch in the contact tip to the appropriate species and the filler
wire diameter.
7.3 Inserting the wire electrode.
1. Make sure that the roller mounted in the drive train correspond to the type and diameter 1. Make sure that the roller mounted in the drive train correspond to the type and diameter
the introduced wire. If the difference roll groove to the diameter of the wire electrode fit groove by
the reversal or replacement of the roll. For steel wire, use of rollers with V-shaped grooves, and
the aluminum wires of the U-shaped grooves may also be used knurled roll groove - are universal
rollers.
2. Place the spool of wire electrode on the spool mounting mechanism, paying attention to 2. Place the spool of wire electrode on the spool mounting mechanism, paying attention to
wire unwinding direction was consistent with the direction of the entrance to the wire drive unit.
3. Lock the spool before falling, by tightening the nut on the body of the reel. 3. Lock the spool before falling, by tightening the nut on the body of the reel.