Magnum IAI9SE, Руководство пользователя, Страница: 19 / 64

19
4. Release the mast lock bar by pulling the safety pin on the mast lock and pulling the lock bar free. Lower the mast
by holding the lower winch control toggle switch to the right until the mast is resting in the transport cradle. Note:
If the lock bar does not pull free, activate lower winch slightly to relieve pressure on the mast lock bar.
5. After the mast is completely down, insert the cradle lock pin and secure it with the safety pin.
6. Position lights to aim at the ground. If the trailer is going to be moved, Magnum Products LLC strongly recommends
that the lights be removed from the mast and stowed for transportation.
REMOVING THE LIGHTS FOR TRANSPORTATION
1. On units equipped with quick disconnect fittings for the lights, disconnect the power
cords from the junction box at the top of the mast. Replace the dust caps on the
junction box. On other units, remove the junction box cover on the top of the mast
and disconnect
ONLY the mast light wires from the terminal blocks. To release
the wires from the terminal blocks, flip the locking levers down and pull out the
appropriate wires (A).
2. Remove the lights by removing the wing nut that holds the light fixture bracket to
the cross tube. Attach the lights to the storage brackets (if equipped) located on
the mast tube on either side of the central lifting eye.
TOWING THE TRAILER
Once the engine is shut down and the mast and lights are properly stowed, the trailer can be made ready for transport.
1. Raise the rear jack completely and release the locking pin to rotate it up into the travel position. Make sure the
locking pin snaps into place.
2. Raise the outrigger jacks completely and release the jack locking pin to swing the jacks up into the travel position.
Make sure the locking pins snap into place. Release the outrigger locking pins and slide the outriggers into the
trailer frame until the locking pins snap into place.
3. Use the drawbar jack to raise or lower the trailer onto the hitch of the towing vehicle. Lock the hitch coupling and
attach the safety chains or cables to the vehicle. Release the jack locking pin and rotate the jack into the travel
position. Make sure the locking pin snaps into place.
4. To ensure proper operation of the jacks, lube the grease fittings located on the leveling jacks.
5. Connect any trailer wiring to the tow vehicle. Check for proper operation of the stop and signal lights.
6. Make sure the cradle locking pin is in place.
7. Make sure the doors are properly latched.
8. If the trailer is going to be driven over rough ground, remove the bulbs from the light fixtures.
9. Check for proper inflation of the trailer tires. The maximum tire inflation is 50 psi.
10. Attach a red flag to the end of the mast before towing.
11. Maximum recommended speed for highway towing is 45 mph. Recommended off-road towing speed is not to
exceed 10 mph or less depending on terrain.