Magnum Industrial MI-81190, Руководство по эксплуатации

Страница: 20 / 44

CLEANING SPIRAL CUTTERHEAD & TIPS (cont.)
Step 3 - Separate the tips from the screws and place in separate containers with a bit of mineral
spirits or non-chlorinated brake cleaner. Once all are removed, wipe down the bare cutterhead
using rags with whichever solvent you chose. Once the oil is wiped off, use an air compressor or a
can of pressurized air to clear each seat and screw hole on the cutter head. This will aid in knife
and cutter tips reinstallation.
Step 4 - Lubricate the Torx screw threads with light machine oil, wipe the excess oil off the threads,
Place each knife in the seat and slightly snug each screw using the Hex Wrench to hold the
cutterhead in position. Once you get a row of tips seated and slightly tightened down, repeat by
going back over each cutter tip and tighten down the screws securely to
48 to 50 inch / lbs.
NOTE: NOT FT/LBS !
After all assembly and adjustment instructions are completed, use a sacrificial board after cleaning
to test for remaining oil.
If oil is still apparent, repeat the cleaning method you used above.