6
Extension Wing Installation
• See Figures 3 and 4.
• Tools: 17 mm wrench, straightedge
Installing the Extension Wings
1. Using a 17 mm wrench, attach the left extension wing (A)
to the table (B) with three each hex cap screws (E), lock
washers (F), and flat washers (G). Leave it snug enough so
the extension wing can still be manually adjusted but do
not tighten.
2. Adjust the extension wing horizontally so the front edge is
flush with the front edge of the table (C)
3. Using a straightedge for reference, adjust the extension
vertically so the top of the extension is flush with the table
top.
4. Tighten the three extension wing mounting screws.
5. Remove the mounting hardware from the table on the
right side.
6. Install the right extension wing by repeating steps 1–4.
ASSEMBLING THE SAW
MAGNUM INDUSTRIAL MI-51180 TABLE SAW
HARDWARE
6 x 7/16" x 1-1/2" hex cap bolts (E)
6 x 7/16" lock washers (F)
6 x 7/16" flat washers (G)
2 x extension tables
FIGURE 3: EXTENSION WING ASSEMBLY
WARNING
Do not connect the saw to a power source until it has been fully assembled.
FIGURE 4: EXTENSION WING HARDWARE
