![background image](http://html1.mh-extra.com/html/magnetek/intelli-protect-nfz-config-5050/intelli-protect-nfz-config-5050_user-manual_3576148034.webp)
Intelli-Protect User Manual
April 2023
4.3.1
Trolley Configuration Steps
Before defining the trolley limit, enter a description to explain the orientation of each side of the trolley such
as “East” or “West.”
Position the trolley to the farthest position away from the trolley reflector so that the displayed laser value is
maximum, and then press the Teach Max button to configure the max limit of the trolley.
If the trolley cannot be moved to the farthest position, enter a trolley position value manually.
Position the trolley to the shortest position, closest to the trolley reflector so that the displayed laser value
is minimum, and then press the Teach Min button to configure the min limit of the trolley. If the trolley
cannot be moved to the closest position, enter a trolley position value manually.
CAUTION
The slowdown and stop distances entered should be determined based on the crane speed and
deceleration rate set by the motor drive. The values entered should be tested experimentally. It is best
practice to set up a temporary test zone in an open area. After setting up this test zone, set the
expected distances required to slow down and stop the crane. Once these values are entered, move
the crane at maximum speed toward the test zone in order to determine if the slowdown distance value
entered is large enough to slow down the crane to the slowdown speed before it enters the stop zone.
Then determine if the stop distance value entered is large enough to stop the crane moving at the
slowdown speed before it enters the protected zone. Modify the slowdown and stop distance values as
needed and repeat these steps.
It is not recommended to use the no-load hook position when setting the NFZ corner boundaries. Doing
this does not take into account the radius of the load; therefore, you will need to add the maximum
radius of the load to both the stop and slowdown distances after determining the required distance
values.
If using Magnetek-brand Sway Control software, make sure to perform the slowdown and stop distance
measurements and configuration with the Sway Control feature enabled. Using Sway Control with
Intelli-Protect requires the most recent Magnetek VFD firmware release. Contact the factory for more
details.
Содержание Intelli-Protect NFZ-CONFIG-5050
