Enrange MLTX Transmitter Instruction Manual
February 2011
Page 14 of 19
2.15. Changing the Channel on the Part 15 Synthesized Transmitter
The channel can be changed by removing the logic board from the bottom housing. Locate the
rotary switches on the RF Transmitter Board (see Figure 2: MLTX Synthesizer Board). The
rotary switch nearest the corner of the board is the “ones” place-value selection (0-9). The rotary
switch near the middle of the board is the “tens” place-value selection (10, 20, and 30).
Figure 2. MLTX Synthesizer Board
AK 20 would be
Tens
Ones
2 0
Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference,
and
2.
This device must accept any interference received,
including interference that may cause undesired
operation.
Warning (Part 15.21)
Changes or modification not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
This portable transmitter with its antenna complies with
FCC’s RF exposure limits for general
population/uncontrolled exposure.
Industry Canada Statement per Section 4.0 of RSP-100
The term "
IC:
" before the certification / registration number only signifies
that the Industry Canada technical specifications were met.
Section 7.1.5 of RSS-GEN
Operation is subject to the following two conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received,
including interference that may cause undesired operation.
Section 2.6 of RSS-102
This portable transmitter with its antenna complies with Industry Canada RF
Exposure Limits for General Population / Uncontrolled Exposure.
