Enrange CHTX Transmitter Instruction Manual
December 2017
Page 38 of 47
Baud Rate
This drop-down menu allows the user to modify the communication speed of the CAN bus network. The
user selectable options are 50K, 125K, 250K, and 500K.
Identifier
This drop-down menu allows the user to select between an 11-bit or a 29-bit identifier.
5.4.2
Saving, Downloading, and Reading the Programs and
Other RCP Software Functions
Saving the Programming File
Once programming is complete, click the File tab at the top of the RCP screen to open the file menu. File
location and name can be selected from this menu. Old files can be deleted, opened, modified and
renamed by this same menu.
Sending a Program to the CHTX
To send a program file to a CHTX transmitter:
1. Insert the USB programming cable and turn on the unit.
2. Click the “send” button on the RCP screen. A dialog box will pop up confirming that you
want to proceed. Check the box marked “I accept,” and then click the “Continue send to
radio” button. On-screen prompts will confirm that the receiver has been programmed or
will warn of any issues.
Data will need to be sent separately for the Unit Info and CAN Configuration screens.
CAUTION
To program or read data from the CHTX, the transmitter must be turned on.
WARNING
After every programming of the transmitter, test the unit by utilizing the appropriate receiver. If the
receiver does not respond, do not activate a function button! The transmitter may have incorrect
programming. Re-check the programming in the transmitter and retest. After activation of the receiver,
functionally test all commands on the transmitter by initially jogging the buttons, then with a full
movement before returning to service. Failure to follow this warning could result in serious injury or
death and damage to equipment.
