Magnescale SJ300 SJ300, Руководство пользователя

Страница: 18 / 76

SJ300 Series 10
(E)
6. Pass through the shaft scale
Move the table so that the head is near either the right or left scale bracket, and then
pass the shaft scale through the head and scale bracket.
If the shaft scale cannot be inserted, loosen the hexagonal bolts
1
,
2
, and
3
enough
so that it can fit through.
7. Temporarily tighten hexagonal bolts
1
,
2
, and
3
Gently tighten hexagonal bolts
1
,
2
, and
3
in that order while being careful not to
apply pressure to the head holder.
Move the table so that the head is near the scale bracket on the opposite side, and then
gently tighten the hexagonal bolts
1
,
2
, and
3
, in that order, in the same way.
8. Tighten hexagonal bolts
1
and
2
Loosen hexagonal bolt
3
, and then tighten hexagonal bolts
1
and
2
using the same
procedure as step 7 while confirming that the shaft scale moves smoothly to the left and
right. Repeatedly move the table, and tighten the bolts gradually in an alternating fashion.
Tightening torque : 5.4 N
•
m
Tighten
Tighten
Hexagon bolt
3
Not parallel
to slider
NG OK