Magner 35-2003 Series, Руководство оператора

Страница: 14 / 20

to-count mode.
- If a “Sensor Error Code” (see page 10) appears on the display instead of “0”,
take corrective actions in accordance with the instructions on page 12.
3. Adjust the thickness adjustment Dial
The thickness adjustment dial is set at 5 as the standard setting.
- For new(thinner) notes, adjust to a lower number: 4, 3, 2 and 1
- For used(thicker) notes, adjust to a higher number. 6, 7, 8 and 9
WARNING
Trial and error is recommended before you make the final
adjustment. Small adjustment of 1/2 number or less works best.
VI. Troubleshooting
If you experience an operational error while using the currency counter, the
following section will help you identify the problem and provide a possible
corrective action.
Should an error occur, a code will appear on the display Refer to the error
code chart on page 11 to determine the cause of the error and its possible
resolution.
In some situations, a problem occurs in the actual operation of the machine
without displaying an error code. If this happens, refer to the operation faults
chart on page 11 to determine the corrective action.
Figure 8 : Note Jam Release Lever Figure 9 : To lockup the Note Jam
Release Lever.
12