OPERATION
1. Before inserting the plug into an electrical outlet, make sure that the electrical supply in
your area matches that on the rating label on the unit.
2. 4-POSITION ROTARY SWITCH & THERMOSTAT DIAL
SYMBOL
FUNCTION
0
OFF
*
Fan mode(no heating)
I
750W(Low heat output)
II
1500W(Full heat output)
a)
Set the thermostat dial to maximum, and the power dial to ‘II’ for fast warm up of a
room. Once the temperature of the room is comfortable, turn it down to a lower
setting to reduce electrical consumption and to prevent the room from becoming too
warm. When the set thermostat level is reached, the unit will automatically switch off.
Once the temperature has fallen below the set level, the heater will switch on again.
b)
The Pilot light will allow you to check the thermostatic regulation. When the
appliance is heating, this pilot light will be on. It will go out when the desired
temperature is reached.
c)
Before removing the plug from the socket, turn the rotary switch to ‘0’.
OVERVIEW
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheating. For example: due to the total or partial obstruction
of the vents. In this case, unplug the appliance, wait about 30 minutes for it to cool and
remove the object which is obstructing the vents. Then switch it back on as described
above. The appliance should now operate normally. Should the problem persist, please
contact Customer Service for assistance.
CLEANING & MAINTENANCE
Before undertaking any cleaning or maintenance on the appliance, disconnect it from
the power supply.
For cleaning it is recommended to use a soft moist rag and neutral detergent. Do not
use an abrasive cloth or devices which could affect the appearance of the appliance.
Check that the hot air outlet and the ventilation inlet are free of dust and dirt. During
cleaning, be careful not to touch the heating elements.
To open the filter on the back for cleaning, press the top of plastic net at back.
