Magnat Audio STYLUS 5000 A, Руководство пользователя

Страница: 8 / 54

8
GB
Dear customer,
Congratulations on your fine new loudspeakers and thank you very much for choosing
Magnat! You have made an excellent choice. The high-quality speakers produced by
Magnat are renowned all over the world.
For best results and to avoid damage please study the instructions and information below
carefully before using your new loudspeakers.
GENERAL NOTES ON CONNECTING YOUR
MAGNAT SATELLITE SPEAKERS
The connectors are located at the rear of the satellite speakers. They are equipped with
a clamping mechanism for cables cross-sections of up to 1 mm
2 . To connect the satellites,
please use normally available 2 x 0.75mm 2 or 2 x 1mm 2 loudspeaker cables. The cables
are to be cut to the required length, the ends stripped and the end of the wires twisted to
make it easier to connect them to the terminals.
Always turn off the amplifier or receiver before connecting or disconnecting loudspeaker
cables. For good sound the cables must be connected so that the speakers are “in phase”.
This means that the black negative terminals on the speakers (-) must be connected to the
negative (-) terminals on the amplifier, the positive (+) speaker terminals to the positive (+)
amplifier terminals. To make this easier one wire of most speaker cables is marked with
a coloured strip or a ridge in the insulation.
Before switching on the system double-check all your connections and make sure that the
terminal screws are tight and that there are no short circuits caused by stray wire filaments
– this could cause serious damage to your amplifier!
CONNECTION TO AN AV RECEIVER
Connection of the system to an AV receiver is shown in figure 1 (receiver without a sub-
woofer output), figure 2 (receiver with low-level subwoofer output), and figure 3 (pre-amp
and power amplifier).
Note: In the receiver set-up, the front, center, and rear loudspeaker channels should be
set to ‘small’ if your receiver supports this option. Please consult the user manual supplied
with your receiver.
Centre, front and rear speakers are identified on the rear of the cabinet. The center loud-
speaker should be positioned on top of or beneath your TV set. The front satellites are
placed to the left and the right of the TV set, preferably at equal distance and at ear-height.
The rear satellites should be located to the left and right behind the listening position and
slightly above ear-height.