Magnat Audio OMEGA SUB 20A, Руководство пользователя

Страница: 8 / 44

GB
• Do not use any cleaning agents or chemical solvents when cleaning, as these could damage the
surface of the device.
• Repairs must always be conducted by qualified specialists, as you might otherwise be exposed to
dangerous high voltage levels or other hazards.
THE ACTIVE SUBWOOFERS OF THE MAGNAT OMEGA RANGE
When connecting your loudspeaker, please make sure that everything has been switched off.
Furthermore, make sure that all loudspeaker cables are connected to the proper poles, i.e. the positive
pole for the output is connected to the positive pole for the input and the negative pole with the negative
pole. Please also refer to your receiver's/amplifier's and loudspeakers' instructions.
POSITIONING
The frequency range reproduced by the subwoofer cannot be pinpointed by the human ear. That's why
positioning generally doesn't present any problems. However, it is preferable to place the speaker close
to the front loudspeaker in front of the listening position. You should also make sure that the distance from
the sides and from the rear to items and walls is at least 20 centimetres as otherwise bass reproduction
may be impaired.
THE SUBWOOFER'S OPERATING ELEMENTS (FIG. 1)
Mains connection (1), mains-voltage switch (2)
The subwoofer is equipped with an integrated amplifier and needs to be connected to a mains outlet by
means of the supplied mains cable. The voltage selector has been set at the factory to 230 V for operation
in Europe.
Warning : Connecting the subwoofer to a 230 V mains outlet while the voltage selector is set to 115 V will
lead to immediate destruction of the amplifier!
Power switch (3), operating state LED (4)
AV input (5)
Connect your receiver's low-level subwoofer output (sub-pre-out) to the subwoofer's AV input (see Fig.
3). You will require a mono-cinch cable for this (not supplied).
Another subwoofer can be connected via the LINK OUT jack (11).
Power switch ON Power switch OFF
The automatic switching on/off is activated.
The subwoofer switches on automatically when it receives a signal
from the receiver, the LED turns green.
It automatically switches to standby after receiving no signals for
some minutes, the LED turns red.
In standby mode the power consumption is 0.5 watt.
The subwoofer is switched off,
LED is off.
This is the setting for when
subwoofer isn't used over long
periods.
GB GB
8