Magnat Audio BULLDOG 7, Важные указания по установке и гарантийный талон

Страница: 14 / 56

14
UNPACKING THE SPEAKER
Please unpack the speaker and accessories carefully and check the contents of the box using the list above. In the event of any transport damage,
please contact your supplier. Keep the packaging material safe. The original packaging will allow you to transport the speaker easily for any
servicing requirements or if you wish to move it at a later date.
SETTING UP THE SPEAKER
• The speaker must be positioned on a level and stable surface.
• The surrounding environment should be dry and free of dust.
• Only use the speaker outdoors if the weather is dry.
• Make sure the connecting cables are laid safely.
• Exposure to direct sunlight or close proximity to heat sources should be avoided.
• Do not place any objects on top of the speaker, especially containers that are filled with liquid.
• The easiest way to operate the speaker is from behind the speaker itself.
• The Bulldog 7 should only be carried using the side handles.
Please note:
If the speaker is moved from a cold environment to a warm environment, condensation may form inside the device. In such a case, please do not
operate the speaker for at least 2 hours.
MOUNTING THE SUPPLIED CASTERS
Four resonance-damping rubber feet are mounted on the underside of the housing. The supplied casters (3, 4) can also be mounted to make
it easier to transport the speaker. Two of the casters are equipped with a parking brake (4). This brake should always be applied (lever located
in the lower position) and only disengaged for transport.
• Carefully lay the Bulldog 7 (1) on its side.
• Use the screwdriver (8) to loosen the fastening screws of the four rubber feet and remove them.
• Please slide a locking washer (6) onto the threaded bolt of each caster (3, 4) first, followed by a plain washer (5) and
then screw the casters (3, 4) into the four screw holes. When doing this, the casters that are equipped with a parking brake (4) should be
mounted at the rear.
• Use the mounting wrench (7) to secure the casters (3, 4) in place via the hexagon nuts (at the upper ends of the threaded bolts).
(3)
(4)
(5)
(7) (6)
(8)
(1)