Magnaflux 43509, Руководство по эксплуатации

Страница: 6 / 44

5
English
Y-6, Y-7, Y-8 Yoke Operating Manual
TROUBLESHOOTING
Problem Possible Cause Possible Solution
Yoke will not
energize
Cord Unplugged Plug cord into a fully grounded outlet
or extension cord
Damaged or defective
cord
Contact Authorized Service Center to
repair or replace cord
Damaged or defective
switch
Contact Authorized Service Center to
repair or replace switch
Blown fuse or breaker in
power supply
Reset breaker or replace fuse
Defective extension cord Replace extension cord
Tripped GFI Reset GFI button
Yoke will not lift test
weight
Foot sections of legs are
worn or rounded
File or grind feet back to original flat
condition or replace
Foot sections turned and
not making full contact
Adjust feet to make flat full contact with
weight
Extension cord too light
to supply adequate
current
See table in precautions section for
proper size
Legs still or do not
move
Leg bolts too tight Loosen slightly with properly sized
wrench
Legs rusted at joints Remove bolts and legs and clean with
wire brush to remove rust. Reassemble
using a rust remover/preventer such
as LPS-2 or equivalent. Retighten bolts
until legs are tight but still move freely.