14
Replacing Domelight Bulbs:
To replace a domelight bulb, repeat the following procedure.
Warning!
in some cases, the domelight maybe hot, proceed
with caution.
1.
Use your fingernail to pull the lever at the end of the
domelight lens forward and downward this will release the
lens to expose the bulb.
2.
Use a pencil to pry out one end of the bulb then pull the
remaining end of the bulb out of it’s clip. Do not use any
metal device to remove the bulb as you may short the ter-
minals together.
3.
To replace the bulb, place the metal ends of the new bulb
onto the metal clips and gently press inward until the bulb
ends are seated into the clips.
4.
Replace the lens by setting the tab end into the slot and
then pressing the clip end into place.
Warning!
Only replace the bulb with the same size
and wattage that you took out. Altering the size, shape
or wattage will result in a damaged housing (melting).
Use only Sylvania or GE model DE3021 for replacements.
Removing Bulb
Removing
Domelight Cover
6.4" and 10.4" Domelight Operation
Domelight Operation:
(Applies to MovieVision flip-down screen with dome lights
built-in only.)
The dome lights located in the MovieVision screen housing
will illuminate whenever the vehicle doors are open just as
the original domelight did.
To activate the dome lights while the vehicle is in motion,
press the domelight switch next to the desired domelight.
Note:
Most American made vehicles (Ford, Chevrolet, Dodge)
have a dashboard light dimmer switch that can be rotated to
the maximum position and the dome lights will illuminate.
Most Japanese or Korean made vehicles do not have this
switch and the lights will have to be turned on manually as
mentioned above.
Domelight
Switch
