blue PiraT Mini
User Guide
Datum: 14.12.2018
Seite 41 von 60
blue_PiraT_Mini_UserManual_V3.4.1.doc
Cable sets
When inserting the cable sets in the usual case, only a slight force is required. At an increased
mechanical resistance during insertion of the cable set, the correct alignment of the pins should
be checked.
Special cable sets are to be manufactured strictly according to the sheet of the instruction man-
ual containing the pin assignment, whereby an extra fuse provided on the cable set must be
considered. The connectors specified in the instruction manual should be used.
Two pairs of pins are assigned to only one type of electrical potential, that means an intercon-
nection to positive electrical potential (Klemme 30/Clamp 30) for one related pair and the nega-
tive one (Klemme 31/Clamp 31) for the other matching pair.
Warning:
A short circuit directly at the connector between clamb 30 and clamb 31 leads to the de-
struction of the device.
The cable sets’ temperature range is restricted to -20°C to +70°C due to the banana plugs.
Mounting
In laboratory setups and automobiles the units must be attached in such a way, that it is en-
sured against dropping, slipping and skidding.
Positioning of the antenna
While operating the device in an automobile, the connected antennas must not be located out-
side of the vehicle.
Replacing the battery
A lithium button cell is located within the device, which must be only replaced by Telemotive AG.
Mechanical exposure
++++++++++++++++++ Environment during ope++++++++++++++++
Height: -300 to 5500 m
++++++++++++++++++ Environment out of s++++++++++++++++++
Height -300 to 12000 m