7
GRIT GUARD TO SHARPENER ASSEMBLY
1.
Remove grinding wheel (see page 8-9)
2.
Align the bottom of the grit guard to the yellow base of the sharpener. The bottom of the grit guard
should cradle the yellow base.
3.
Use two #10 self-tapping screws to connect the grit guard bottom to the sharpener
4.
By doing this step first it will be easier to see which holes line up with the top of the grit guard and
the yellow grinding wheel compartment.
5.
Use two button head screws from the inside of the grinding wheel compartment, use the two nylon
nuts to connect the top of the grit guard to the grinding wheel compartment.
WARNING
WHEN USING ELECTRIC TOOLS, BASIC SAFETY PRECAU-
TIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE
THE RISK OF FIRE, ELECTRIC SHOCK, AND PERSONAL
INJURY.
TESTING THE MAG-8200
Before turning the unit on, test the unit by checking if the grinding wheel moves freely. Ensure the MAG-8200
ON/OFF switch is in the OFF POSITION, plug the MAG-8200 into a 15 amp, 110 volt outlet. Switch the ON/OFF
switch to the ON POSITION to test the motor. The motor should achieve FULL speed in 1-2 seconds. If it does
not, (see page ******) or contact MAGNA-MATIC (800-328-1110).
