8
MONOSTICK 200i PFC
2.1 UPON RECEIPT AND CLAIMS
Be sure that you have received all the items that
you have ordered. In case of any item is missing or
damaged, contact your supplier immediately.
In the event of damaged or missing delivery,
it to the shipping agency and MAGMA
MEKATRONIK with the photocopy of shipping bill.
E-mail: [email protected]
Fax: +90 236 226 27 28
draw
up a record, take a photo of the damage and
report
ú
ú
ú
ú
Standard box contains:
Power Source
H
Cable
Earth Clamp Cable
User Manual
Electrode older
2. INSTALLATION
2.2
INSTALLATION AND WORKING RECOMMENDATIONS
• DO NOT USE THE MACHINE WITH LONG
ELECTRIC CABLES AT CONSTRUCTION
SITES! Do not forget that electric cable carries
220V/50 Hz and these cables are not suitable to
work in harsh environments, they can easily wear
and tear which may lead to electric leakage to the
metals where welders may be working on.
ELECTRIK SHOCK CAN KILL or cause people to
FALL DOWN from dangerously high places
(iskele). Instead, ALWAYS use long
WELDING CABLES for safety reasons
•
For a better performance, keep the machine at
least 20 cm away from the surrounding objects.
Beware of excessive heat, dust and humidity
around the machine. Try not to operate the
machine under direct sunlight. Machines should
be operated on
when ambient
air temperature exceeds
.
like
scaffolding
.
lower capacities
40ºC
•
Avoid welding at outdoors where it is windy and
rainy, if this is a must, protect the welding area with
curtains, mobile screens or tents.
•
se suitable welding fume extraction systems.
Use breathing apparatus if there is a risk of inhaling
in confined places.
•
Respect the duty cycles given at the data plate.
Exceeding the duty cycles frequently can damage
the machine and this would void the warranty.
•
Do not use stronger fuses than those stated on the
data plate
•
Ensure that the earth clamp is tightly connected as
close as possible to the welding location. Do not let
welding current flow through any media other than
welding cables; e.g. over the machine itself, gas
tubes, chains, ball bearings, etc.
U
.
2.3 CONNECTIONS FOR MMA WELDING
SWITCH ON the machine via power switch
and
check if power LED
lights up and cooler fan
works.
(1)
(2)
According to the polarity of the electrode to be used,
i
s into the appropriate socket
them
clock-wise
Below table is given as a reference for current
adjustment of mild steel electrodes, please refer to
the electrode manufacturer's recommendations.
nsert welding cable
and tighten
by turning
.
(
)
5-6
Connect the earth clamp tightly to the workpiece
as close as possible to the welding area.
Adjust the desired current and the machine is ready
to weld.
While inserting the plug into the
socket, pay attention that main
switch is positioned to “OFF” “0”.
Before plugging your machine to the
electrical line, check if the correct
voltage exists.
Diameter
Rutile
Basic
Cellulosic
2.0
2.5
3.25
4.0
40-60 A
60-90 A
60-90 A
60-100 A
100-140 A
100-130 A
70-130 A
140-180 A
140-180 A
120-170 A
--
--
INSTALLATION AND OPERATION
Содержание MONOSTICK 200 PFC
Страница 1: ...www oerlikon com tr MONOSTICK 200 PFC...
