EN
www.magmaweld.com
14
USER MANUAL | KULLANIM KILAVUZU
ID 500 M/MW PULSE
2.1 Delivery Control
Symbols and their meanings on the device;
2.2 Installation And Operation Recommendations
• Lifting rings or forklifts should be used to move the machine. Do not lift the MACHINE with the GAS CYLINDER. Place the power supply on a hard,
level, smooth surface where it will not fall or tip over.
• For a better performance, place the machine at least 30 cm away from the surrounding objects. Pay attention to overheating, dust and moisture near
the machine. Do not operate the machine under direct sunlight. If the ambient temperature exceeds 40°C, operate the machine at a lower current or
a lower operating cycle.
• Avoid welding outdoors in windy and rainy weather circumstances. If welding is necessary in such cases, protect the welding area and the welding
machine with a curtain and canopy.
• When positioning the machine, make sure that materials such as walls, curtains, boards do not prevent easy access to the machine’s controls and
connections.
• If you weld indoors, use a suitable smoke extraction system. Use breathing apparatus if there is a risk of inhaling welding fumes and gas in confined
spaces.
• Observe the operating cycle rates specified on the product label. Suspending operating cycle rates can damage the machine and this may invalidate
the warranty.
• The supply cable must comply with the specified fuse value.
• Tighten the ground wire as close as possible to the workpiece. Do not allow the welding current to pass through equipment other than the welding
cables such as the machine itself, gas cylinder, chain and roller bearing.
• When the gas cylinder is placed on the machine, secure the gas cylinder by connecting the chain immediately. If you will not place the gas cylinder
on the machine, secure the gas cylinder to the wall with a chain.
• The electrical outlet on the back of the machine is for the C02 heater. Never connect a device to the C02 outlet other than the C02 heater!
Make sure that all the materials you have ordered have been received. If any material is missing or damaged, contact your place of purchase immedi-
ately.
Scope of supply;
• Welding machine and connected mains cable
• Grounding clamps and cable
•
Gas
Hose
•
Warranty
Certificate
• Gas cylinder fixing chain
• User manual
In case of a damaged delivery, record a report, take a picture of the damage and report to the transport company together with a photocopy of the
delivery note. If the problem persists, contact the customer service.
Welding process is dangerous. Proper working conditions should be ensured and necessary precautions should be taken. Specialists are
responsible for the machine and have to be equipped with the necessary equipment and those who are not relevant should be kept away
from the welding area.
This device is not compatible with IEC 61000-3-12. If it is desired to connect to the low voltage mains used in homes, it is essential that the
installer or the person who will operate the machine to make the electrical connection has information on the machine’s connectivity. In
this case the responsibility will be assumed by the person who will perform the installation or by the operator.
The safety symbols and warning notes on the device and in the operating instructions must be observed and the labels must not be
removed.
Grids are intended for ventilation. The openings should not be covered in order to provide good cooling and no foreign objects should be
inserted.
INSTALLATION
Installation
