ELECTRODE SPARK ADJUSTMENT
CAUTION: Spark can cause small shock. Do not leave
fingers on or near electrode wire while engaging igniter.
• Electrode wire should be approximately 1/8” from gas
exit hole in burner. Carefully adjust wire if required.
5
A
DISASSEMBLY & RE-ASSEMBLY
• Remove radiant plate’s retainer pin (see B) and remove radiant plate by sliding it out
of securing tabs (see E).
• Remove burner retainer pin (see C), remove burner. Inspect burner, remove obstructions.
CAUTION: WHEN REPLACING BURNER, CUT SLOTS IN BURNER MUST FACE DOWN.
• Remove lid by removing hinge screws and nuts with 3/16” hex key wrench
(supplied) and 1/2” wrench or pliers. CAUTION LOCK NUTS MUST BE INSTALLED WITH
LOCKING INDENT MARKS SHOWING (see F). IMPROPER INSTALLATION WILL DAMAGE
HINGE SCREWS AND LOCK NUT.
• Clean as indicated in Maintenance (page 6).
• To disconnect or replace igniters ceramic electrode. First remove two screws on valve
chamber (see D) and remove cover plate. Gently pull wire off connector (see D).
Remove electrode screw and nut with a small Phillips head screwdriver and 1/4”
wrench or pliers. Gently pull electrode with wire out of grill body inspect for damage,
replace if necessary.
• To re-assemble, reverse above procedure.
B
C
E
Electrode
Disconnect
wire
D
Screws
Battery
Locking
Indents
F
Retainer Pin
Retainer Pin
Radiant Plate
Radiant Plate
Securing Tabs
Burner
