• USE OUTDOORS ONLY.
• DO NOT USE THIS APPLIANCE INSIDE THE BOAT OR ANY ENCLOSED SPACE.
• GRILLS RADIATE HEAT. CLEARANCE FROM COMBUSTIBLES, 24” SIDES AND BACK. NEVER USE UNDER
AWNINGS, PATIO COVERS, ETC.
• USE PROPANE GAS ONLY. FUEL STORAGE SHOULD BE IN COMPLIANCE WITH THE AMERICAN BOAT AND
YACHT COUNCIL (ABYC) STANDARDS A-1 (9), MARINE LIQUIFIED PETROLEUM GAS (LPG) SYSTEMS.
• FOR NATURAL GAS APPLICATION CONTACT MAGMA.
• ALWAYS LIGHT GRILL WITH LID OPEN.
• NEVER LEAVE HOT GRILL UNATTENDED.
• USE HOT PAD WHEN HANDLING.
• ALWAYS TURN GRILL OFF AFTER USE.
• NEVER LEAVE GAS CYLINDERS AND REGULATOR CONNECTED WHEN STOWED.
• STORE GAS CYLINDERS IN WELL VENTILATED AREA.
• DO NOT STORE GAS CYLINDERS INDOORS, IN DIRECT SUNLIGHT, BELOW DECKS ON BOATS, OR IN LOCKERS
NOT APPROVED FOR BUTANE OR PROPANE STORAGE.
• CAUTION: CHECK FOR GAS LEAKS EACH TIME CYLINDER IS CHANGED.
• NEVER CHECK FOR GAS LEAKS WITH A FLAME!
• DO NOT BLOCK, RESTRICT, OR OTHERWISE OBSTRUCT COMBUSTION OR VENTILATION
AIR OPENINGS.
• DO NOT MODIFY THIS APPLIANCE.
• CHECK THAT VALVE SEALING WASHER (A) IS IN PLACE AND IN GOOD CONDITION
BEFORE CONNECTING THE GAS CONTAINER.
• INSTALL CANISTERS IN WELL VENTILLATED AREA AND AWAY FROM OPEN FLAME, HEAT
SOURCE OR SPARKS. KEEP AWAY FROM OTHER PEOPLE OR FLAMMABLE MATERIALS.
IMPORTANT SAFETY WARNINGS
INSTALLATION INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE OPERATING.
2
Each Magma
®
Gas Grill is individually fire tested before it leaves the factory.
For this reason, the burner on your grill may be slightly discolored.
CONTROL VALVE REGULATOR
•Uses standard 1-lb. disposable propane canisters
(DOT-39 NRC 228/286).
•Prior to installing valve, become familiar with the
valve function and graphics on valve knob. Never
force the knob. Always turn or push gently.
•Turn control valve to “lock” and install gas canister
being careful not to cross the threads. Check for leaks
prior to use, by brushing soapy water solution around
threads and orifice hole checking for bubbles.
•Position valve with gas bottle as shown
(A)
. Gently insert
valve stem into valve chamber. Rotate until valve stem key
aligns with lock detent allowing valve to fully insert. Rotate gas
canister down, so knob faces you
(B)
or straight up
(C)
depending on application.
Pull straight out on valve to check that it is locked in place.
•Valve may seem loose. This is OK. It is meant to be loose so that the valve and fuel
canister may swing freely. Valve does not have to be snug-fitting to be safe or
function properly.
A
