DOUBLE GRIP HANDLE PADDLE BRAKE ACTUATOR ASSEMBLY (NO. 16 HANDLE)
Parts A-G provided in double grip handle brake conversion kit 304161.
1. Remove the lower existing pan head machine screw and locknut on each side of the hand truck handle
using the #2 Phillips head screwdriver and the 7/16” wrench.
2. Position the LH handle mounting bracket (C) as illustrated in Figure 4 with the tab (TAB) facing away from
center of the truck and secure it with a ¼” x 2¼” long pan head machine screw (A) and 1/4”-20 locknut
(B).
3. Slide a 3/8” washer (F) on the LH end of the handle actuator (E) and insert actuator through the hole in the
LH handle mounting bracket (C) and hold in place. Slide a 3/8” washer (F) on the RH end of the handle
actuator then slide the RH handle mounting bracket (D) over the end and slide bracket into place.
4. With the brake actuator handle in place resting on the tabs, assemble the RH handle mounting bracket to
the side rail using a ¼” x 2¼” long pan head machine screw (A) and ¼”-20 locknut (B). Securely tighten
the mounting bracket using the #2 Phillips head screwdriver and the 7/16” wrench.
5. Install a cotter pin (G) on the inside of each 3/8” washer (F) in the holes provided. Using the needle nose
pliers bend the end of the cotter pins to keep secure.
Item
Description
Qty.
Part No.
A
Pan head machine screw - 1/4”-20 x 2-1/4” long
2
80263
B
Hex locknut - 1/4”-20
2
80675
C
Handle mounting bracket LH
1
304153
D
Handle mounting bracket RH
1
304154
E
Double grip brake handle actuator
1
304151
F
Flat washer for 3/8” bolt
2
80702
G
Cotter pin - 3/32” x 3/4”
2
81075
Figure 4
4
G
A
B
C
D
E
F
TAB
F
G
