Magio MG-585, Инструкция по эксплуатации

Страница: 24 / 28

22
3. The lower blade should project forward, with respect to the upper
one by 1.2 mm.
4. If you could not level the blades, drip a few drops of oil on the
blades, turn on the machine for a while (30-40 seconds). After that,
turn off the machine.
5. Slightly loosen the screws of the lower blade and align the blades.
6. After aligning the blades, be sure to tighten the mounting screws
of the lower blade.
Oiling instructions
Comb guides
Length adjustment lever
1. For optimum cutting performance, it is highly recommended to
oil the blades after every use.
2. When using the oil for the first time, unscrew the cap and cut off
the very end of the plastic tube with a pair of scissors.
3. Remove the blade guard and switch the appliance on.
4. Holding the clipper at a 45 degree angle, gently squeeze the oil
tube and apply 2 drops directly onto the blades.
5. Leave the unit on for a further few seconds to allow the oil to
thoroughly spread along the length of the blades.
6. Switch off the unit and remove any excess oil by gently dabbing
with a cloth before using on hair.
This appliance is supplied with 4 comb guides: 3mm / 6mm / 10mm
/ 13mm
1. To attach a comb guide, ensure the appliance is switched off.
Position the comb guide over the front of the clipper blade and
slide over the head. Push and click the rear of the comb guide into
position.
2. To remove the comb guide, ensure the appliance is switched
off. Push the tab on the rear of the comb guide away from the head
and lift off.
The taper control lever enables fine cut adjustment for precision
clipping.
- To increase the cutting length, push the lever down.
- To reduce the cutting length, push the lever up.
EN