MAGINON RC-1, Инструкция по эксплуатации

Страница: 12 / 16

10
6.5. Radio function
The Maginon® Reverse Camera system also allows transmission of the played back MP3 files to an
existing radio receiver and thus playback through the in-car audio system.
Keep FM button
depressed for 3 seconds to activate “FM Mode“ radio playback. Using the  /
 buttons, select a FM frequency (between 88.0 and 107.9) to be used for transmission to the radio
receiver. You should select a frequency not used by any radio stations in your area. There should also
be an adequate gap between the selected frequency and frequency of any existing radio station to
achieve the best possible transmission quality.
As soon as playback is activated through the radio, the loudspeakers of the mirror are switched off.
To change back to playback through these loudspeakers keep button depressed again for 3
seconds. The display then indicates “Speaker mode“.
The volume of the radio playback can also be adjusted using the volume control on the mirror.
7. Conformity
This device corresponds with section 15 of the FCC guidelines. The operation is subject to the
following two conditions:
„
This device may not cause any disruptions.
„
This device must be able to absorb all disruptions, even disruptions that result in undesired
operation.
This device was tested and corresponds in accordance with section 15 of the FCC guidelines with
the threshold values for a digital device from the B class. These threshold values serve as an
appropriate protection against interference disruptions in living spaces. This device creates and uses
high frequency energy and can emit this as well.
If the device is not connected and used pursuant to the instructions provided here, the device may
significantly disrupt radio transmissions. Nevertheless, despite following the instructions it is
possible for disruptions to occur by certain devices
If this device causes disruptions by radio or television reception, which you can determine by
turning the device on and off, you can try to solve this problem with one or several of the following
measures:
„ Adjust the receiving antenna or place it in a different location.
„
Increase the space between the equipment and receiver.
„
Connect the device and the receiver to two different electrical circuits.
„
Contact a specialized merchant or an experienced radio/television technician.
This device was labelled with the CE marking, in accordance with the following
European Directives:
Low Voltage Directive 2006/95/EC
EMC Directive 2004/108/EC
The EU declaration of conformity can be requested from the address listed on the warranty card.