Magicar M881A, Руководство по установке

Страница: 35 / 60

35
EN
connect lines to the relay outputs used to block the starter.
2
– green - Ignition Input
- connect to the switchboard (to the +12V wire when ignition on).
3
– red/black
- Negative door switch input ( - )
4
– red
- Positive door switch input (+12V)
5
– orange/black
- Negative parking lights input (-). When switching on Magicar M881A this will indicate the
lights are on.
6
– orange
- Positive parking lights input (+). When switching on Magicar M881A this will indicate the
lights are on.
7
– grey/black
- Negative hood switch input (-)
8
– brown/black
- Negative trunk switch input (-)
9
–black/white
- Foot brake input reacting on (+)
- additional outputs
Additional outputs controlled by the remote control. For
settings see programming menu 2-08, 2-09.
When connecting AUX, always check the power
supply, so it will not damage any equipment in the
car.
When connecting AUX to electric windows you
must use an additional 12V relay.
If AUX is connected via the additional relay, use a 30A
fuse when connecting to the relay.
1
– yellow
- AUX1 output, rating capacity - 250mA.
2
– yellow/white
- AUX2 output, rating capacity - 250mA.
- Interface for Module CAN BUS MAGICAR
- Antenna
- Temperature sensor
- LED indication
- RPS sensor
CONNECTOR 4 - red
CONNECTOR 5 - black
CONNECTOR 6 - blue
CONNECTOR 7 - blue
CONNECTOR 8 - white
CONNECTOR 9 - white
87 87a
86
Switching circuit
+12V
AUX (-)
30
85
switch
Cutt off