Specifications
MultiView™ II XRTx Installation and User Guide
3
Chapter 3
Specifications
This section describes the following specifications:
•
General specifications
•
VGA interface specifications
•
DDC support
•
Auxiliary signal support
•
CAT5 cable compatibility
3.1
General Specifications
The following table lists the general specifications of the XRTx.
Table 2: XRTx General Specifications
Item
Description
Cable Required
Category 5, 5e, 6 cable. Shielded or unshielded twisted pair. Low-skew preferred.
Compliance
CE, FCC Class A, IC Class / Class A, I.T.E Device, RoHS.
Video Support
VGA (RGB+HV). Also, component (YPbPr) and composite video formats are supported by
using an optional media break-out cable.
Resolution &
Refresh Rate
See the
DDC Support
topic
Interface Signal
Details
Video-input:
Standard VGA interface specifications apply. DDC is supported.
Standard auxiliary Signals (including -A and –S versions):
L+R summed audio input: 47K ohms input impedance. A source device with 600 ohms
maximum output impedance is recommended. (analog audio input mode).
Simplex RS-232 input: 4.75K ohms input impedance (RS-232 mode).
SPDIF input: 75 ohms input impedance (S/PDIF input mode).
Duplex (232) option module:
Audio: Not supported.
Duplex input: 4.75K ohms input impedance.
Duplex (SA) or (SAP) option modules:
Stereo L/R audio input: 10K ohms input impedance. A source device with 600 ohms
maximum output impedance is recommended.
RS-232 input: 4.75K ohms input impedance.
Local-output port
drive impedance
The video output will be a direct copy any video input (even if the video input is in
component (YPbPr) or composite format). If the video input is VGA, then standard VGA
interface specifications apply (at local video-output port) and DDC is supported.
Audio
Characteristics
Standard (A) version: Left+Right summed audio.
(232) version: This option module does not support audio.
(SA) & (SAP) versions: Left/Right true stereo audio.
Serial
Characteristics
Standard (S) version: Simplex-serial, any speed up to 115.2K baud. Transparent to format
and protocol.
Duplex (232) version: Any speed up to 115.2K baud (depending on application).
Transparent to format and protocol. Refer to Appendix-B for more information.
Duplex (SA) version: Speed fixed at 9600 baud. Transparent to format and protocol.
Duplex (SAP) version: Speed is adjustable in 9 steps from 1200 to 115.2K baud; format is
fixed to 8 data no parity; transparent to protocol.
Connectors
Standard connectors:
(2) VGA-female: Video in/out.
(1) RJ-45: MultiView™ II CAT5 link output.
(1) 4 position phoenix: Auxiliary signal input.
(1) Coaxial (5.5mm OD, 2.5mm ID, 11mm L) jack: DC power input.
For (232), (SA) or (SAP) versions:
(1) DB9-F: Serial I/O.
Temperature
Tolerance
Operating: 32 to 104°F (0 to 40°C)
Storage: -4 to +140°F (-20 to +60°C)
Humidity Tolerance
Up to 80% non-condensing