
Fly Series User Manual rev 1.21
15
in
fo@mag-audio
.c
om
Tel./F
ax:
+
38 044 277
-4
7-89
www
.mag-audio.com
Fly Sub 15 and Fly Sub 18
built-in power amplifier:
1
2
3
4
5
9
12
6
10
11
13
14
1. VOLUME KNOB. Used for adjusting the volume of the system.
Remember to turn the volume dowm before connecting/
disconnecting INPUT or LINK connectors.
2. LIMIT LED. Is lit when limiter is operational, indicating excessive
signal through the system.
3. TEMP LED. Is lit when tempreture protection is in place,
indicating overheating.
4. SIGNAL LED. Is lit when signal is present on the INPUT
connector.
5. READY LED. Is lit when system is fully operational.
6. PRESET LEDS. Indicate the currently selected system preset.
For preset description, refer to the “4.4 System Operation -
Configurations” section of this manual, page 13.
7. PRESET SWITCHES. (Fly 6 only). Used for preset selection.
8. PRESET REFERENCE TABLE. (Fly 6 only). Shows preset
switches combinations.
9. LINK CONNECTOR. Used for linking additional compactible
system to same signal source.
10. INPUT CONNECTOR. Used for connecting the system to the
signal source (mixing console etc.)
11. PRESET SELECT BUTTON. Used for switching currently
selected system preset.
12. HEAT SINK. Large heat sink for effective heat dissipation.
13. PowerCon A CONNECTOR. Used for connecting mains
supply to the system.
14. PowerCon B CONNECTOR. Used for feeding the mains
supply to the additional system.
LIMIT
TEMP
SIGNAL
READY
PRESET4
PRESET3
PRESET2
PRESET1
PRESET
SELECT