K65cc/KSS60cc
01/2022
27
Use the following procedure to install the
parallel guide fence:
1.
Loosen the wing screws (5) on both sides.
2.
Insert the parallel guide fence (C) into the
guide provided for this purpose.
➢
It can be mounted on the left or right side
of the machine.
3.
Tighten the wing screws (5) on both sides.
✓
The parallel guide fence is installed.
Fig. 23: Installing the parallel guide fence
Use the following procedure to adjust the
cutting width:
1.
Loosen the wing screws (5) on both sides.
2.
Adjust the parallel guide fence.
3.
Tighten the wing screws (5) on both sides.
✓
The cutting width is adjusted.
Fig. 24: Adjusting the cutting width via the parallel guide
fence
In addition, the parallel guide can also be used as a double support for a better guidance
of the hand-held circular saw. Simply turn it over (the guide tab (20) points upwards).
Alternatively, you can guide the machine with the parallel guide fence along a guide rail
or a wooden ledge fixed on the workpiece. This requires the parallel guide fence to be
rotated so that the guide tab (20) points upwards.
