Maestro MR928 Скачать руководство пользователя страница 3

4

5

Safety instructions

When using your appliance, basic safety precautions should always be 

followed,including the following:

SPECIAL INSTRUCTIONS

WARNING! 

- If install the heater in the bathroom, it must be installed in a place where couldn’t 

be touched once in bathtub or shower bath

- Do not allow water and moisture on the electrical parts of the device.

- Never immerse the appliance, cable or plug in any liquid.

- Never touch the appliance with wet or damp hands.

- Do not insert any object through the heater outlet or air intake grilles.

Failure to observe these rules may result in electric shock!

- It is prohibited to use the device in rooms with flammable, highly explosive 

vapors in the air or near explosive and flammable objects and liquids and 

powders e.g. FUEL, OIL, GAS, EXPLOSIVES, COAL OR SUGAR POWDERS 

etc.)

- Keep the heater clean. Do not allow any objects to enter any ventilation or 

exhaust opening as this may cause electric shock, or fire or damage to the heater.

ATTENTION!

 

do not cover, If covered, there is the risk of overheating and 

can cause a fire risk!

- Strictly observe the distances to the surrounding objects indicated in the chapter 

«Operation».

- Do not place the convector on unstable surfaces or soft surfaces (for example 

on a high pile carpet).

- Do not position the heater in front or immediately below, a wall socket.

- DO NOT leave the appliance without supervision when it is connected to the 

power supply.

- Do not using the heater with a programmer, timer or any other device that 

switches the heater on automatically. The use of such devices is dangerous and 

can cause a fire risk.

- Ensure the power supply to the socket into which the heater is plugged is in 

accordance with the rating label on the heater and that the socket is earthed. Only 

plug the appliance into an outlet with an earthed (ground) contact.

- Always unplug the heater when not in use. Do not pull the cord to unplug the 

heater.

- Using of low-quality electric extension pieces or adapters of mains plug may 

cause damage of the electric device and fire. 

- This appliance is not intended for use by persons (including children) with 

reduced physical, sensory or mental capabilities, or lack of experience 

and knowledge, unless they have been given supervision or instruction 

concerning use of the appliance by a person responsible for their safety.

ATTENTION!

- The parts of the device become very hot during operation. Be careful because 

you may burn yourself greatly by touching it.

- After it was turned off, allow the unit to cool down before storage.

In case of failure to observe the above mentioned rules there arises the 

danger of burning!     

- Children should be supervised to ensure that they do not play with the 

appliance. 

- Close supervision is necessary when the appliance is used near children or 

pets.

- Do not leave the appliance unnecessarily plugged in. Disconnect the plug from 

the mains when the appliance is not being used.

- Do not use outdoors. 

- Do not operate the appliance if damaged, after an appliance malfunctions or it 

has been damaged in any manner, return to at authorized service engineer for 

repair.

- In the interest of safety, regular periodic close checks should be carried out on 

the supply cord to ensure no damage is evident. Should there be any signs that 

the cord is damaged it must be replaced with original one.

- Do not let the cord touch hot surfaces and sharp objects.

- Never move or pick up the heater when it is turned on. Do not drop or overturn 

the appliance.

- It is forbidden to block air inlet and outlet grids during operation.

WARNING! Blocking of the air during operation may cause overheating, 

malfunction of the heater, and fire!

- Overheating can be caused by obstruction to the air circulates through the grilles 

of the heater (e.g. by paper, cloth, curtains etc.). If this occurs the heater turns off 

automatically. Please disconnect the heater and allow it to cool for 30 minutes. 

Remove any obstruction and turn the heater back on.

Despite the fact that the device is equipped with protection against overheating, it 

can be damaged, if air flow stops.

THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY.  Do not use it in industrial 

or commercial areas (e.g. construction sides, stores etc.), places with high dusty 

or humidity in the air. 

DO NOT USE THE APPLIANCE FOR ANYTHING OTHER THAN INTENDED 

USE.

EN

Содержание MR928
















Отзывы: