Maestro MR258, Руководство пользователя

Страница: 4 / 23

6 7
- Do not use while bathing or in a shower.
- Never drop or insert any object into any opening on this appliance.
ATTENTION!
Be careful because the heated surfaces become very hot during
operation.
Do not touch the heating elements to avoid burns, do not keep the
device near your temples. Let the device cool down after switching
off.
In case of failure to observe the above rules there arises a
danger of receiving burns!
- Hair sprays and fixers contain inflammable components. Do not
use them when the device is ON. Do not direct sprays of any kind or
water on the device.
- Dry your hair before using the device.
THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT
USE THE APPLIANCE FOR ANYTHING OTHER THAN INTENDED
USE.
- Do not use it for commercial purpose.
Actions in extreme situations
- If your device has fallen into water or water has penetrated it,
immediately disconnect it from the mains without contacting the
device itself or the water.
- If there appears smoke, sparkling, strong smell of burning
isolation, immediately stop using the device, disconnect the device
from the mains and apply to the nearest service center.
Operation
Before startup
- Remove all wrap materials and stickers
- Make sure that all the parts of appliance don’t have damages.
- Unwind the power cord completely.
- Place the device on a flat dry heatproof surface.
- Connect the device to the mains.
The hair must be clean, dry and brushed.
ATTENTION! A small quantity of smoke or a specific smell may
appear after the first switching ON as the result of conservation
materials contact with heating element. This is a normal
phenomenon and it shall disappear after several minutes of
operation.
- The required temperature is set with a temperature control handle.
Low temperature is preferable for thin or damaged hair, average
temperature – for normal and high temperature – for dense hair.
Mark «150» corresponds to minimal temperature; mark «230»
corresponds to maximal temperature.
- Place the switch (2/Fig. 2) to the position «ON». Light indicator (4/
Fig.1) will go red and the tongs will begin heating.
- By turning the temperature control handle clockwise you may
rise the temperature of the heated surfaces, by turning it counter
clockwise you may lower the temperature. The heating up takes
about 1 minute.
- When the set temperature is reached the light indicator becomes
green and the device is ready for operation.
- For setting hair, divide it into three parts: upper, middle and lower.
- Brush each forelock before straightening. Begin from the lower
part. When lower strands are completely straightened, proceed to
EN