7
Do not handle very hard products such as: serials, rice,
coffee, ice, frozen products.
Preparation for work
- Before the first use remove packing material, make sure that all
parts of the device are not damaged.
Before the first use wash all removable parts with warm water and
detergent and thoroughly dry.
The cover of the chopper cup (H/ Fig.1) and the drive and gear of
the wire whisk (D/ Fig.1) can be washed under a weak flow of water
from the tap. However, do not submerge them in water completely.
Wipe the electric drive case from outside with a soft slightly wet
cloth, and then rub it dry.
- It is prohibited to submerge the case of electric drive, its mains
connector and the plug in water or any other liquid.
Attention!
At the time of the first switching on the device, a specific
smell or smoke may appear for a short time. These are normal
phenomena due to the presence of preservation materials on the
electric drive motor. They shall disappear after several minutes of
the device operation.
The use of submerged blender.
Insert the shank of the submerged blender (С/ Fig.1) in the case
of electric drive (A/Fig.1) as far as it will go and turn clockwise until
fixed.
Connect the device to the mains 220 – 240 V, 50Hz.
To avoid sloping out the dishes you are using must be filled with
products not more than by 2/3. Always use submerged blender
for mixing ingredients with water or other liquid. Do not mix dry
products.
- Before switching on put the blender into the container with the
products to be mixed.
EN
