STEP 3
– Insert the bracket with the new M8 bolts and washers provided right
through the aluminum spacers and into the mounting holes of the bottom bar
bracket. Run the bolts in with your fingers to get them started then bolt them
down so the final result looks like the photo below.
NOTE: Tighten the front bolt
completely first, then tighten the back bolt to factory specifications.
Actual KTM model in photo may differ - the installation is the same
STEP 4
– Repeat steps 1, 2 and 3 for the other set of brackets on the other bar
clamp. The final result will look like the photo on page 1 of this manual.
