With the help of an assistant mark the
desired location you want to mount the fan.
Use a tape measure to square the brackets
to ensure proper alignment.
NOTE:
For single person install removing
the roof is ideal for the next four steps. Also
be wary of mounting fan in a location that
will obstruct other accessories.
Using a 1/4” drill bit, drill through roof
at the four mounting locations.
(A) Rubber washer goes between brackets
and top.
(B) Attach fan to roof using supplied hardware
as shown. DO NOT over tighten hardware as
this could cause damage to the roof.
NOTE: Supplied spacers can be used to
provide more of an angle if needed.
Insert the four 6mm x 45mm bolts
through the top of the roof with rubber
side of washer down as shown. If you
are installing the fan on a TXT the
four 6mm x 70mm bolts are needed.
(A)
(B)
