6
2. Connection and Operation
Hold handle of the cleaner and place it in water slowly, wait until the cleaner is fully immersed in water
and discharges no air, and confirm that the buoyancy cable is not knotted or tangled by an obstacle.
Only allow enough cable for the robotic cleaner to reach the furtherest point of the pool +1metre.
This will allow the robot to swivel and reduce cable tangling.
a)
Insert power line on the left of the control box into the power supply (AC 100-240 V / 50-60 Hz).
b)
At this time, START/ STOP button of the control box will be yellow, while the cleaner enters standby
status.
Only put sufficient cable into the pool so the cleaner can reach the furthest point + 1 metre. All excess
cable should be outside of the pool water. This will allow the cleaner to reach all areas of the pool
whilst providing some tension for the swivel to operate as intended.
3.
4.
5.
Madimack Installation Manual GT560.indd 6
Madimack Installation Manual GT560.indd 6
19/5/2023 5:06 pm
19/5/2023 5:06 pm
