16
Manual
Раскрой и крепление покрытия торца
Fig. 15
2.
Cut ridge coverage pieces located above the door at
the place of installation from remaining pieces. Mark
coverage by elements 4в with allowance aligning bottom
edge of the sheet with bottom edge of element
5
(
Fig.
15
).
marking
4в
5
Cutting and fastening of coverage
coverage
Avoid excessive tightening of fastening screws to prevent crumbling of
polycarbonate and destruction of cellular.
Fig.16
3.
Mount side pieces of coverage in accordance with
Fig.16. Holding a piece of coverage, fasten it with screws
and washers by elements 6к, 7, 8б 21 and by angles
using tap screws with washers. Holes for screws are
drilled by boring bit of 5 mm diameter from inside of
greenhouse through holes in frame elements. Mount
top pieces of coverage fastening them on angles with
washers and tap screws. Cut overlapping with side
pieces.
4.
Even coverage pieces by arcs
4н
and
4в
using a
knife and mount sealing profi le in accordance with
Fig.
17.
5
.
Fasten pieces of coverage on door with washers
(
Fig.18,19
), making runoff by one side (
Fig.23
), closing
cellular beforehand (with adhesive tape). Mount sealing
profi les along the door contour in accordance with
Figures
19,21,22
.
Fig.17
elements
4В, 4Н
and 1
end
coverage
end sealer
coverage
washer
screw М5х35
pr
ot
ectiv
e la
yer
