Macnaught K57-01, Инструкция по эксплуатации

Страница: 3 / 8

DAAGG Issue © 2022 3
BULK FILL WITH A MACNAUGHT
J3 GREASE PUMP
Note: Select the correct follower position ( Fig 1).
1) Lock the follower rod (Fig 2).
2) Slide the filler bleeder valve into the nozzle on the
pump
3) Fill with grease until the groove in the rod is visible
at the end of the barrel.
4) Repeat steps (8), (9), (10) refer (How to bulk Fill).
HOW TO INSTAL A CARTRIDGE
Note: Select the correct follower position (Fig 1).
Repeat steps (1) to (2) above
1) Pull the follower rod back until the rod groove can
be pulled into the barrel slot.
2) Remove the large end cap from the cartridge.
3) Slide the large open end first into the barrel.
4) Remove the small end cap from the cartridge.
5) Screw the gun body assembly onto the barrel.
6) Repeat steps (8), (9), (10) as above.
(Fig 6)
* Use P.T.F.E. tape while connecting the thread
joints
* Fill the grease gun with grease and remove the
trapped air by unscrewing the filler bleeder valve (5)
* Connect the air hose to the inlet valve (4) and start
the air supply
INSTALLATION
OPERATING INSTRUCTIONS
For single shot operation, press button (7) to move
the slider (6) forward as shown in fig 4
For continuous mode operation, slide the slider (6)
back as shown in fig 5
Slide backwards for
continuous mode
Press button for sin-
gle shot operation
SINGLE SHOT
CONTINUOUS FLOW
(Fig 4)
(Fig 5)
COUPLER REMOVAL