Maclaren mx3, Инструкция по эксплуатации, Страница: 9 / 9

Instructions
IMPORTANT:
• READ THESE INSTRUCTIONS CAREFULLY BEFORE USE AND KEEP
THEM FOR FUTURE REFERENCE.
• YOUR CHILDREN’S SAFETY MAY BE AFFECTED IF YOU DO NOT FOLLOW
THESE INSTRUCTIONS.
3
1. ASSEMBELING/ DESEMBELING THE FRAME
A. Open the frame.
B. Pull the front legs forward and connect them into the
armrest bar until the pop up pins are engaged.
Pull on the legs to ensure that they are properly engaged.
2. ATTATCHING AND DETACHTING THE TODDLER SEAT TO
THE MACLAREN MX3 FRAME
Before attaching the seat to the stroller ensure that the leg
rest is folded down.
A. Place the toddler seat in position, the bottom bar of the
seat should rest on the footplate and the clips should rest
on the stroller frame at either side.
B. Push the side clips onto the frame and secure by closing
the clip around the tube.
C. Secure the side legs of the toddler seat to the stroller using
the straps provided, wrap the strap around the seat legs
and side bars of the stroller and fasten the clip.
D. Pull the strap tight.
CAUTION: The security of the fitting should be tested by pulling
up on the toddler seat before putting the child into the seat.
To detach the toddler seat reverse this process.
3. SEAT BELT/SHOULDER HARNESS OPERATION
WARNING: Avoid serious injury from falling or sliding out.
Always use the crotch strap in combination with the waist belt and
shoulder straps.
TO FIT HARNESS:
A. Insert both fasteners securely into clasp.
B. Adjust strap lengths. Belt, crotch strap and harness should
be snug.
C. ‘D’ rings are included for an additional harness, if desired.
TO RELEASE HARNESS:
D. Squeeze fastener prongs and pull apart.
4. UNFITTING AND REFITTING THE SEAT
A. Undo the zips on the seat on both sides of the bumper bar.
B. Undo the poppers on the crotch restraint on the front of
the bumper bar.
C. Undo the strap at the back of the seat by sliding it through
the buckles.
D. Undo the remaining straps attaching the seat to the legs
and the side of the bumper bar, slide the straps through
the hole in the ‘D’ ring.
To refit the seat, reverse this process.
EN