Mackworth Raiser, Руководство пользователя

Страница: 17 / 28

999061 – Revision A P a g e | 17 of 28
7.0 ENVIRONMENTAL - STORAGE AND OPERATING
CONDITIONS
The Transfer Aid is intended for internal use within normal environmental conditions.
It is not intended to be used in environments where there are rapid changes in the environmental temperature and
humidity during intended use .
7.1 Normal Operating Conditions
+5°C to +40°C (41°F to 104°F) at a relative humidity between 15% to 90% RH, non-condensing but not requiring a water vapour
pressure greater than 50hPa and atmospheric pressure between 700hPa to 1060hPa.
7.2 Shipping and Storage Conditions
-25°C to +5°C (-13ºF to 41ºF) with any humidity level.
+5°C to +35°C (41°F to 95°F) at a relative humidity up to 90%.
+35°C to 70°C non-condensing at a water vapour pressure up to 50hPa.
8.0 DISPOSAL
When the Transfer Aid has completed its life cycle and can no longer perform to its intended use safely the Aid
must be decommissioned by an approved Service Engineer. The following specifies the importance of correct
disposal procedure including local laws and being environmentally friendly.
Please observe the local laws on recycling and respect the current laws for disposal within the community the
device is being used within. If there is any uncertainty of the below guidelines, contact your local authorities to
determine the proper method of disposal of potentially biohazardous parts and accessories.
The relevant components utilised in the manufacture of the device that can be recycled at the end of the
device life are:
Fully recyclables: Consideration when Recycling:
Steel frame (Handle, Base) Knee Pad
Castors
Initial packaging of the device (cardboard)
Metallic fixing – screws etc.
The product may be contaminated and has to be disinfected before recycling or disposal.
See section 10.3 ‘Cleaning’ for details of how to do this.
Table 7