32
Onyx 1620i
Appendix D: Rack Ear installation instructions
The Rack Ear Kit allows the Onyx 1620i mixer to be
mounted in a standard 19” rack. It will be out of harm’s
way and the band may continue tearin’ it up without
fearing any consequences. The mixer takes up 12 rack
spaces. Be sure to allow for an extra space, or two,
above to make connections. The kit contains two rack
ear brackets and eight black screws (M3.5 x 8mm).
Tools Required:
One phillips screwdriver and a musical selection of
your choice...good tunage makes everything in the world
oh so much better.
Procedure:
1. Turn off the mixer and disconnect all cords.
2. Place the mixer face up on a soft and dry flat
surface.
3. Remove the eight silver screws as shown below
and hand them off to someone else who will
probably do a better job at keeping them in a
safe place for further use.
4. Using only the new black screws supplied,
secure the rack ear brackets to each side of
the mixer as shown. Hand-tighten the screws
securely.
5. Offer up the mixer to the rack and secure it in
place with at least four rack screws (not
supplied). Remember to leave enough room at
the top to attach the AC power cord and
any other connections needed.
6. You did it! Step 6 does not exist except to
congratulate you on a job well done!
