4
Command List
CMD
Options
Description
BAS
[<+9 to -6]
Set Message Bass Level.
BBT
*Memory Bad Blocks Test.
CFG
*Restore Default Configs.
DIR
Directory of Message Priority.
DEL
[<1-99>]
*Delete Message.
DLD
[<1-99>]
Download MPG Message.
DLY
[<0,+/-99>] (+=sec, -=min)
Delay Before 1st Play Start.
LST
This Commands Listing.
PAS
[<0,+/-99>] (+=sec, -=min)
Pause Between Play Repeats.
PLS
[<1-99>]
Number of Plays per Trigger.
PLY
[<1-99>,<1-99>,<0,+/-99>]
Play Message,Repeat,Delay.
PRI
[<1-99>,<E>nable/<D>isable]
Set Priority Message,Enable.
REC
[<1-99>,<1-99>,<0,+/-99>]
Record Message,Delay,Time.
RST
Warm Reset System
SHP
*Init Configs & Erase Messages.
STP
Stop Message Playback.
STS
[<0>Off/<1>On]
Display Play Status Messages.
SYS
Display System Information.
TRE
[<+9 to -6]
Set Message Treble Level.
ULD
[<1-99>]
Upload MPG Message.
* = Confirmation Required
1.1.4. Bass- BAS
This command is to set the bass level of the MacFi-se .
Syntax;
BAS
value
Where;
value
= 0 or -6 to +9, (default = 0)
Example;
BAS+9<CR> sets bass level to +9dB
1.1.5. Memory Bad Blocks Test - BBT
Allows the user to format the internal SD Card. The process is completed when
the MFI> prompt is given to the user. All audio memory will be erased by
performing this function.
Syntax;
BBT
Example;
BBT<CR> will trigger Y/N confirmation in order to proceed with the format
9
1.1.19. Initialize Configuration Table - SHP
This command allows the user to format the memory card and reset system
settings to factory default. This command will erase the entire memory and reset
all of the configurable settings to those specified in the Product Specification.
Example;
SHP<CR>
The system may take up to 10 sec before it’s ready to receive new commands.
1.1.20. Stop-STP
This command stops the playback or recording of messages and clears the
message queue.
Example;
STP<CR>
Will stop any currently playing message, or recording message on the MacFi
system. If nothing is currently playing or recording, this command will have no
effect.
1.1.21. Display Status - STS
This command toggles the display of RS-232 feedback from the MacFi-se ON or
OFF. With Status ON, the system will send a message to the RS-232 port
indicating that the particular message has started/stopped. This status may be
used to control other systems based on the mode of the MacFi-se.
Syntax;
STSvalue
Where;
value is 0 for off and 1 for on
Example;
STS1<CR> will turn display status on
1.1.22. System Information- SYS
This is a diagnostics feature for testing purposes only. Certain status information
from the MacFi unit will be output to the user when this command is entered.
Example;
SYS<CR>
1.1.23. Treble- TRE
This command is to set the treble level of the MacFi-se .
Syntax;
TRE
value
Where;
value
=
value
= 0 or -6 to +9, (default = 0)
Example;
TRE+9<CR> sets treble level to +9dB
