Mack TerraPro LEU 2010, Руководство оператора

Страница: 104 / 225

OPERATION 93
Bleeding the Cab Tilt System
Note:
In order to bleed the system, the cab must be in the lowered position.
Note: To perform a system bleed, the following steps must be performed in the
designated order:
1. Connect all hydraulic lines.
2. Tighten all connections (except two) at the tilt cylinder.
3. Tighten one connection at each latch cylinder.
4. Fill the pump reservoir to the top with MACK specified oil.
CAUTION
Do not refill the reservoir with the cab in the RAISE position.
5. Close and tighten the fill plug.
6. Shift the pump control lever to the LOWER position and pump until the
LOWER lines are bled; also tighten the corresponding connections.
7. Shift the pump control lever to the RAISE position and pump until the
RAISE lines are bled; also tighten the corresponding connections.
8. Bleed the latch cylinders and tighten the connections.
9. Bleed the push port of the tilt cylinder and tighten the connections.
10. After the entire system has been bled, shift the pump control lever to the
LOWER position; then check and refill the reservoir, if necessary.
Note: The recommended type of fluid for the cab tilt system is CF-A (MIL-H-5606E);
the approximate capacity is 1.4 liters (3 pints).
WARNING
The pump control lever must be in the LOWER position before operating
the vehicle.