MachineryHouse CL-60A, Инструкция по эксплуатации

Страница: 34 / 89

37
8. Chucks and Chucks Mounting
When fitting chucks or faceplates, first ensure that spindle and chuck tapers are
scrupulously clean and that all cams lock in the correct positions; see Fig. It may be
necessary when mounting a new chuck to re-set the cam lock studs (A). To do this,
remove the cap-head locking screws (B) and set each stud so that the scribed ring (C)
is flush with the rear face of the chuck-with the slot lining up with the locking screw
hole.
Now mount the chuck or faceplate on the spindle nose and tighten the six cams in
turn. When fully tightened, the cam lock line on each cam should be between the two
V marks on the spindle nose.
If any of the cams do not tighten fully within these limit marks, remove the chuck
or faceplate and re-adjust the stud as indicated in the illustration. Fit and tighten the
locking screw (B) at each stud before remounting the chuck for work. A reference
mark should be made on each correctly fitted chuck or faceplate to coincide with the
reference mark scribed in the spindle nose.
This will assist subsequent remounting. Do Not Interchange Chucks Or Face Plates
Between Lathes Without Checking For Correct Cam Locking.
Page 34 Instructions Manual for CL-60A (L604) 07/09/2017