MachineryHouse CL-60A, Инструкция по эксплуатации

Страница: 27 / 89

30
6. Lubrication
6-1 Lubrication in headstock
An oil-splash feed is utilized in the lubrication system of Headstock. On top of the
Headstock there grooves surrounded providing lubricant flow into the spindle bearing
along the groove, then finally flow down on the bottom of the box. When supplying
the lubricant, remove the cap of oil sight glass. To drain the waste oils away, a drainer
hole located in the right side downward of the Headstock.
Please take good care of checking whether the Headstock has been filled up with
lubricant or not when you purchase the machine. If negative, use as show in the figure
(6-4) lubricating oil. We request you to change the lubricant at first month and then do
once every two months so to assure the gears are working in the best conditions.
6-2 Lubricating in Gear Box and Apron
1) Gear Box is oil-bath lubricated to insure the lifetime of gears and bearing. It is
recommended the lubricant to be changed every six months.
2) Apron is also oil-bathed. If the oil quantity in Apron is lower than center level of oil
sight glass, then it is time to add up some oil to standard level.
6-3 Useful Reference Lubricating Table for other Mechanism
No. Location How
How
many
For how
long to
Oil exchange time
1
Headstock
Remove the screws of filler
hole on left side up
L Once a month
One month, then every
two month
2
Gear Box
Open top cover remove the
screws of filler hole
L Once a month Every half year
3
Apron
Remove the screws of filler
hole
L everyday
4
Compound
Rest
By oilcan approp. everyday
5
Auto Feed
lever
By oilcan approp. everyday
6
Tailstock By oilcan approp. everyday
7
Lead screw By oilcan approp. everyday
8
Bracket of
Three Rods
Remove the screw of filler
hole
approp. everyday
9
Bedway Press the manual oil pump approp. everyday
Page 27 Instructions Manual for CL-60A (L604) 07/09/2017