MachineryHouse C6246, Инструкция по эксплуатации

Страница: 22 / 89

23
with its highest point outward can touch the Auto Stop Centering (15) and stops
Apron Feed, it will pass through all the rest of Eccentric Centering Rings and will not
activate at all.
4-12 Tailstock Operation
1) Tailstock Hand-wheel Dial is divided 0.02mm per graduation. Tailstock
Hand-wheel (28) revolves one cycle clockwise, the quill of Tailstock feeds 5mm. If
revolves anti-clockwise, the quill runs backward; when it runs to the last the center
will be automatically telecasted.
2) By pushing the Tailstock Locking Lever (30) forward, you can steady the quill of
Tailstock. If you wish to steady the Tailstock or the lathe bed you only need to push
Tailstock Clamping Lever forward.
3) Tailstock Centering
Let loose of the Adjustment Screw (26) of Tailstock, then adjust the other side,
tighten screws on both sides after adjustment.
4 - 12
Page 22 Instructions Manual for CL-60A (L604) 07/09/2017