Page 27
The following must be conducted by a supervisor or a qualified individual experienced in
electro-mechanical equipment.
Ensure that there are no persons close to the machine.
Ensure that there are no obstructions in or around the machine.
Turn the speed control knob fully clockwise Max speed = 280 RPM (normal
configuration).
9. Press the start button and observe the machine to turn the drive shaft and in turn
the mixing shaft inside the nozzle tube. A scraping noise is normal, if heard, being
the mixing tines running close to the inside of the tube, for maximum shear
effect..
10. Turn the direction switch from FWD to REV observe the machine to turn the
shaft and in turn the mixing shaft, in reverse.
11. Press the stop button.
12. Connect a water supply to the inlet connection of the water control.
13. Connect the water pipe from the water control to the connection on the nozzle
tube.
14. Turn the speed to minimum, and press the start button.
15. If the water doesn’t turn on, increase the speed knob on the control box until the
water valve “clicks” and turns on the water. The motor should not run, but a quiet
“whistle noise” from the motor is normal.
16. Once the water is proven to operate, then press STOP and turn off the machine.
17. The machine is now ready for use, by trained and qualified operators.
