33
should be later than the setting in TIME1 . ALMSVR IP is used to
transmit the alarm signals to the designated IP server.
Select the corresponding channel in CH, and choose the protocol
of the brand name of corresponding pan-tilt decoder in PROTOCOL.
ADDRESS is the address of the corresponding platform decoder.
IP is set by using
pq
or input the exact numbers to change the IP
address
（
IP address setting can only be realized in this term
）
. The related
SUBNETMASK and GATEWAY should be set according to the IP
address. MONITOR and PLAYBACK can be changed by using
pq
（
TCP/IP
、
MULTICAST
）
.
Reserve the setting in SAVE, and restart the recorder.
Note:
MULTICAST
：
The users with manage can monitor each channel freely, and
other users can only view after them. 5 users at maximum.
TCP Protocol
：
All users are able to monitor any channel. User shall select
according to necessity. If the transmission is under Internet,
TCP should be chosen. 2 users at maximum
Select the relevant channel in CH. Open or close the function in
STATE. Choose how long you want to continue the recording
（
10
、
20
、
30
、 … …
90SEC
）
when motion is detected. ALMOUT controls the
alarming state for motion detection. SENS has three levels: LOW, MID,
HIGH.
AREA can be accessed by pressing
ENTER
. The setting area can
Pan-tilt control
PANTILT CONTROL
CH 1
PROTOCOL NONE
BAUDRATE 1200
ADDRESS 000
SAVE CANCEL
Network
NETWORK SETTING
IP 192-168-
000-141
SUBNETMASK 255-255-
255-000
GATEWAY
192-168-
000-001
WEB PORT 00080
TCP PORT 37777
MONITOR TCP
PLAYBACK TCP
SAVE CANCEL
MOTION DETECTION SETUP
CH 1
DELAY 30 SEC
ALMOUT OFF
SENS MID
AREA SET
TIME1 08:00AM
–
08-00PM ON
TIME2 08:00AM
–
08-00PM
OFF
SAVE CAMCE;
Motion detection