IntroductIon
The Motion Alert’s unique passive infrared system
concentrates motion detection on an area you select.
The motion detector responds only when a person
moves into range of the sensor and will sound an
alarm. In the Entry Chime mode, the chime will sound
each time motion is detected.
Features
• motion sensor detects motion & activates alarm
• programmable security code and entry delay timing
• adjustable sensor head
• built-in high output 105dB alarm
• alarm/door chime option
• panic button
• program & low battery indicator
• verification tone for key pad and arm/disarm
• 9V battery operated/AC adaptor compatible
(not included)
Important saFety tIps
• Do not install alarm where it will be exposed to
direct sunlight or rain
• The alarm siren is very loud, never put the unit close
to your ear
• The unit should be directed away from heat sources
such as radiators, heating ducts and stoves. If the
alarm sounds at random, it is possibly located too
close to a heat source. Change the location or direc-
tion of the unit.
• If you make an error or the unit does not respond
properly during the programming procedure—or if
you forget the password—remove the battery and
wait 3 minutes for the unit to rest, then replace the
battery. This resets the system to the default settings
so you can begin reprogramming.
InstallatIon
Remove the screw from the battery compartments
cover, slide it down to remove the cover.
Install an alkaline 9
Volt battery (fIg. 1)
Replace the battery
cover and the screw
For wall
mount
Using the battery cover
as a template, mark the
location of holes and in-
stall anchors and screws.
Place the unit over the
screws and slide the unit
down to secure in place.
(fIg. 2)
We suggest that you mount the unit between 3 to 6.5
feet (1 to 2 meters) above the floor and position the
adjustable sensor head to the left or right to obtain the
best coverage of the protected area.
NOTE: unit can also be installed with Velcro
(not included)
For shelF top InstallatIon
Turning the sensor head clockwise, rotate it 180 de
-
grees, so it is facing backwards. The head can then be
adjusted upward to the desired angle for coverage. Lay
the unit flat on top of a shelf as shown in figure 3.
to use an ac adaptor
(not included)
The unit can be powered with an AC adaptor with out-
put 9V DC 200 MA with 3.5mm diameter male plug,
center positive (+). Plug to the adaptor jack on the side
of the unit
(fIg 4).
program settIngs
The security code is factory set at 0-0-0. After you
install a battery you can program your own security
code, using up to six digits. If more than 6 digits are
entered you will hear an error tone.
continued on back >>>
S E C U R I T Y
�
I N T E R N A T I O N A L
®
MOTION DETECTOR
WITH SECURITY ALARM
MODEL #80200
fIg. 1
fIg. 2
fIg. 3
fIg. 4
®
