![background image](http://html1.mh-extra.com/html/macdon/tm100/tm100_manual_3456647123.webp)
262150
109
Revision A
6.4
Hydraulics
The TM100 Tractor Mount Float Module
’
s hydraulic system drives the header drapers and knife drives. The tractor
’
s
hydraulic system drives the reel hydraulics and header tilt.
The oil reservoir is located at the center of the float module frame. Refer to the inside back cover for oil requirements.
6.4.1
Checking Oil Level in Hydraulic Reservoir
Check the hydraulic oil level in the reservoir every 25 hours.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1034679
A
Figure 6.13: Oil Level Sight Glass
2.
Check the oil level using sight glass (A) with the float
module set to operating height and angle (10 degrees
forward and 400 mm [15 3/4 in.] above the ground).
NOTE:
Check the level when the oil is cold.
3.
Ensure the hydraulic oil level is between the low and full
indicator marks.
6.4.2
Adding Oil to Hydraulic Reservoir
Top up the oil in the hydraulic reservoir if the oil level is below the low indicator mark.
To change the hydraulic oil, refer to
6.4.3 Changing Oil in Hydraulic Reservoir, page 110
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Set the tractor mount float module to operating height and angle (400 mm [15 3/4 in.] above the ground and 10
degrees forward).
2.
Shut down the engine, and remove the key from the ignition.
3.
Allow hydraulic oil to cool down before attempting to add fluid.
Содержание TM100
