214075
52
Revision A
7.3
Checking Roll Timing
Check roll timing if excessive noise is coming from the conditioner rolls.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator’s seat for any reason.
Roll timing is factory-set and should not require adjustment. However, if there is excessive noise coming from the
conditioner rolls, the timing will need to be adjusted. Refer to
7.3.1 Adjusting Roll Timing, page 52
.
7.3.1
Adjusting Roll Timing
Figure 7.4: Conditioner Drive
1.
Loosen four bolts (A) in slots of yoke plate (B) on upper
roll universal shaft.
NOTE:
Only three of the four bolts are shown in the illustration.
