MacDon R113, Руководство оператора

Страница: 184 / 276

MAINTENANCE AND SERVICING
3. Inspect de fl ectors (A) and (B) for damage and wear,
and replace if de fl ectors are worn at the center to
50% or more of their original thickness. Do
NOT
repair de fl ectors.
4. Examine drums for signi fi cantly sized dents. Replace
dented drums to prevent an imbalance in the cutterbar.
5. Check for loose or missing fasteners and tighten or
replace missing fasteners.
WARNING
Ensure cutterbar is completely clear of foreign
objects.
Foreign objects can be ejected with
considerable force when the machine is started and
may result in serious injury or machine damage.
6. Close cutterbar doors.
Figure 4.114: Rotary Deflectors
Removing Driven Rotary Deflectors and Driveline
DANGER
To avoid bodily injury or death from unexpected start-up or fall of a raised machine, stop engine, remove
key, and engage header lift cylinder lock-out valves before going under machine for any reason.
CAUTION
Exercise caution when working around the blades. Blades are sharp and can cause serious injury. Wear
gloves when handling blades.
NOTE:
Images shown are for left side rotary de fl ector and driveline—right side rotary de fl ector and driveline is similar.
1. Open cutterbar doors (refer to
Opening Cutterbar
Doors, page 159
).
Figure 4.115: Cutterbar Doors
169820
174
Revision A